- Available in 110v and 240v x 1ph
CWL200 & CWL200L = 110v & 240v
CWL200 & CWL301L = 240v only
- Operates on standard household power supply
In case of 110v version via transformer
- Dynamic and mechanical brake
Provides instant and safe braking
- Lightweight and compact design
For easy installation
- Foot mounted
Can be installed upside down
- Enclosed drum flange
Prevents ropes becoming trapped between
drum and support castings
- Complete with wire rope
Galvanised for longer life
- 360º weighted safety hook
Swivel type with safety catch
- 10 metre pendant control
Plug-in, with 2 buttons and emergency stop
- 3 metre power lead
Pre-wired to the winch with commercial type plug
- Motor rating IP44
- Pendant control, plug in extension – for additional 10m length
- Remote controls – please call Sales
NEW EUROPEAN STANDARDS & BHW GROUP
New Harmonised European Standards: BS EN14492-1 for power driven winches, BS EN14492-2 for power driven hoists provide the means for conformity to essential Health and Safety requirements of the EC Machinery Directive.
Conformity to these standards is the joint responsibility of the supplier, the installer and the company operating the product.
BHW Group products are fully compliant and carry a UKCA and CE mark. A Declaration of Conformity is also supplied with each winch or hoist.
Our aim at BHW Group is to ensure the correct machine is supplied to suit the application and we welcome the opportunity of discussing the proposed application and offer advice. It will help us considerably if information regarding the maximum and average loads to be lifted or pulled – and approximate frequency of use can be provided.
For hoisting applications the minimum breaking force (MBF**) of the wire rope must be 5 x the lifting capacity of the hoist. The ratio of wire rope diameter to mean drum diameter* is usually at least 15:1. This will vary according to the application, the average operating time per day and the average and maximum weights being lifted.
For pulling applications. As a general rule winches used in pulling applications rarely see their maximum rated capacity and are used intermittently for short running periods. In these applications the wire rope MBF** to winch rating can be a minimum 2:1 and the ratio of wire rope to mean drum ratio* as low as 10.1. In applications where the winch is used for longer running times and more frequently sees higher loading conditions the wire rope to MBF** should be 3:1 and the ratio of wire rope to mean drum ratio* 12:1.
For recovery vehicles the permissible standard of wire rope MBF** to winch rating can be a minimum 2:1 and the ratio of wire rope to mean drum ratio* only 10:1. This minimum standard is permitted because the running time is so short and the winch rarely sees maximum load.
Wire rope capacities the maximum amount of wire rope on the drum must leave a freeboard to the top of the drum flange of 1.5 x wire rope diameter to prevent the wire rope coming off the drum.
Winches and hoists with capacities over 1000kg must be load limited.
* Mean drum diameter = the drum diameter plus the diameter of the wire rope. ** MBF = the Minimum Breaking Force of the wire rope.